STM32L073RBT6 LQFP64 ST Microelectronics микросхема аналого-цифровой микроконтроллер

Сфера деятельности компании: производство приборов учета тепла

Адрес места нахождения: Свердловская область

Способ оплаты: Отсрочка платежа

Периодичность поставок: Регулярная

Предполагаемый объем товаров (шт./тонн и т.д.): 30000

STM32L073RBT6  LQFP64 ST Microelectronics микросхема аналого-цифровой микроконтроллер


The ultra-low-power STM32L073xx microcontrollers incorporate the connectivity power of the universal serial bus (USB 2.0 crystal-less) with the high-performance Arm Cortex-M0+ 32-bit RISC core operating at a 32 MHz frequency, a memory protection unit (MPU), high-speed embedded memories (up to 192 Kbytes of Flash program memory, 6 Kbytes of data EEPROM and 20 Kbytes of RAM) plus an extensive range of enhanced I/Os and peripherals. The STM32L073xx devices provide high power efficiency for a wide range of performance. It is achieved with a large choice of internal and external clock sources, an internal voltage adaptation and several low-power modes.

The STM32L073xx devices offer several analog features, one 12-bit ADC with hardware oversampling, two DACs, two ultra-low-power comparators, several timers, one low-power timer (LPTIM), four general-purpose 16-bit timers and two basic timer, one RTC and one SysTick which can be used as timebases. They also feature two watchdogs, one watchdog with independent clock and window capability and one window watchdog based on bus clock.

Moreover, the STM32L073xx devices embed standard and advanced communication interfaces: up to three I2Cs, two SPIs, one I2S, four USARTs, a low-power UART (LPUART), and a crystal-less USB. The devices offer up to 24 capacitive sensing channels to simply add touch sensing functionality to any application.

The STM32L073xx also include a real-time clock and a set of backup registers that remain powered in Standby mode.

Finally, their integrated LCD controller has a built-in LCD voltage generator that allows to drive up to 8 multiplexed LCDs with contrast independent of the supply voltage.

The ultra-low-power STM32L073xx devices operate from a 1.8 to 3.6 V power supply (down to 1.65 V at power down) with BOR and from a 1.65 to 3.6 V power supply without BOR option. They are available in the -40 to +125 °C temperature range. A comprehensive set of power-saving modes allows the design of low-power applications.

All features

Ultra-low-power platform

1.65 V to 3.6 V power supply

-40 to 125 °C temperature range

0.29 µA Standby mode (3 wakeup pins)

0.43 µA Stop mode (16 wakeup lines)

0.86 µA Stop mode + RTC + 20-Kbyte RAM retention

Down to 93 µA/MHz in Run mode

5 µs wakeup time (from Flash memory)

41 µA 12-bit ADC conversion at 10 ksps

Core: Arm® 32-bit Cortex®-M0+ with MPU

From 32 kHz up to 32 MHz max.

0.95 DMIPS/MHz


Up to 192-Kbyte Flash memory with ECC (2 banks with read-while-write capability)

20-Kbyte RAM

6 Kbytes of data EEPROM with ECC

20-byte backup register

Sector protection against R/W operation

Up to 84 fast I/Os (78 I/Os 5V tolerant)

Reset and supply management

Ultra-safe, low-power BOR (brownout reset) with 5 selectable thresholds

Ultra-low-power POR/PDR

Programmable voltage detector (PVD)

Clock sources

1 to 25 MHz crystal oscillator

32 kHz oscillator for RTC with calibration

High speed internal 16 MHz factory-trimmed RC (+/- 1%)

Internal low-power 37 kHz RC

Internal multispeed low-power 65 kHz to 4.2 MHz RC

Internal self calibration of 48 MHz RC for USB

PLL for CPU clock

Pre-programmed bootloader

USB, USART supported

Development support

Serial wire debug supported

LCD driver for up to 4×52 or 8×48 segments

Support contrast adjustment

Support blinking mode

Step-up converted on board

Rich Analog peripherals

12-bit ADC 1.14 Msps up to 16 channels (down to 1.65 V)

2 x 12-bit channel DACs with output buffers (down to 1.8 V)

2x ultra-low-power comparators (window mode and wake up capability, down to 1.65 V)

Up to 24 capacitive sensing channels supporting touchkey, linear and rotary touch sensors

7-channel DMA controller, supporting ADC, SPI, I2C, USART, DAC, Timers

11x peripheral communication interfaces

1x USB 2.0 crystal-less, battery charging detection and LPM

4x USART (2 with ISO 7816, IrDA), 1x UART (low power)

Up to 6x SPI 16 Mbits/s

3x I2C (2 with SMBus/PMBus)

11x timers: 2x 16-bit with up to 4 channels, 2x 16-bit with up to 2 channels, 1x 16-bit ultra-low-power timer, 1x SysTick, 1x RTC, 2x 16-bit basic for DAC, and 2x watchdogs (independent/window)

CRC calculation unit, 96-bit unique ID

True RNG and firewall protection

All packages are ECOPACK2



Сбросить пароль

Пожалуйста, введите ваше имя пользователя или эл. адрес, вы получите письмо со ссылкой для сброса пароля.